Conduit bending calculators
18 calculators, one per bend. Each gives the marks and the shrink as you type — tape fractions or millimetres — with the drawing, the steps at the bender and a "send it to yourself" button under the answer. Not sure which one? Start with the offset, or read the guides.
Offsets
- Conduit offset Rise and angle to the distance between marks and shrink.
- Offset angle finder Rise and the room you have to the exact angle, marks and the chip angle that fits.
- Rolled offset Rise and roll to the true offset and roll angle.
- Box offset The small step that seats a connector in a knockout.
- Parallel offsets Keep a rack of conduits even through the jog.
- Conduit shrink The length an offset pulls out of the run.
- Bending multipliers Every angle: exact multiplier and the shop rule.
Saddles
90s and stubs
- 90° stub-up Height and take-up to the mark from the end.
- Kick 90 A 90 stub with a kick in the tail to lift the run.
- Back-to-back bend Two 90s a set distance apart, as a squared U.
- Bender take-up Find your own take-up from a test bend.
- Deduct and gain Your bender’s deduct and gain to the cut length and marks of two 90s.
Sweeps and turns
Nothing matches that. Try one word — offset, saddle, 90 — or browse all calculators and all guides.
¿Ve algo incorrecto en esta página? Repórtelo
Gracias — su reporte fue enviado.
No se pudo enviar. Vuelva a intentarlo más tarde.
Herramientas afines por correo — opcional
De vez en cuando — como máximo un correo cada dos semanas — las calculadoras y referencias que encajan con lo que usted usa, aquí y en fieldcalc.net y sparkytools.net. Una sola lista para los tres, un clic para salir. Marque la casilla y luego confirme desde su bandeja de entrada; no se envía nada antes.